This is all the step u have to do Project 1 – PLC ladder logic program for door

This is all the step u have to do
Project 1 – PLC ladder logic program for door control
Use LogixPro software to write and test a ladder logic program to control the door simulator in LogixPro. The requirements for this ladder logic program are as follows:
Door movement stops immediately when the Stop Switch is initially pressed, and remains stopped if the switch is released.
Pressing the Open Switch causes door to open if not already fully open. The opening operation continues to completion even if the switch is released.
Pressing the Close Switch causes door to close if not already fully closed. The closing operation continues to completion even if the switch is released.
If the door is already fully opened, pressing the Open Switch does not energize the motor.
If the door is already fully closed, pressing the Close Switch does not energize the motor.
The Ajar Lamp illuminates if the door is not either fully closed or fully opened.
The Open Lamp illuminates if the door is fully opened.
The Shut Lamp illuminates if the door is fully closed.
Submission Requirements
Submit by uploading the LogixPro Ladder File (RSL file) of your work with filename lastname_firstname_project1
Grading Rubric
Grading of your submitted project:
80% for meeting all 8 of the requirements listed above (10% for each requirement), 10% for clear labeling of all program instructions used, 10% for proper ladder logic rung use (i.e., one rung per OTE instruction)